Réactifs et instruments pour l'immunologie, la biologie cellulaire et la biologie moléculaire.
 
> DFHBI [1241390-29-3]

DFHBI [1241390-29-3]

Imprimer Imprimer
Identifiez-vous

Référence HY-110250-5mg

Conditionnement : 5mg

Marque : MedChemExpress

Contactez votre distributeur local :


Téléphone : +1 850 650 7790

Mass (g) = Concentration (mol/L) × Volume (L) × Molecular Weight (g/mol)

Mass
=
Concentration
×
Volume
×
Molecular Weight *

Concentration (start) × Volume (start) = Concentration (final) × Volume (final)

This equation is commonly abbreviated as: C1V1 = C2V2

Concentration (start)

C1

×
Volume (start)

V1

=
Concentration (final)

C2

×
Volume (final)

V2

In Vivo:

Select the appropriate dissolution method based on your experimental animal and administration route.

For the following dissolution methods, please ensure to first prepare a clear stock solution using an and then sequentially add co-solvents:
To ensure reliable experimental results, the clarified stock solution can be appropriately stored based on storage conditions. As for the working solution for in vivo experiments, it is recommended to prepare freshly and use it on the same day.
The percentages shown for the solvents indicate their volumetric ratio in the final prepared solution. If precipitation or phase separation occurs during preparation, heat and/or sonication can be used to aid dissolution.

  • Protocol 1

    Add each solvent one by one:  10% DMSO    40% PEG300    5% Tween-80    45% Saline

    Solubility: ≥ 1.43 mg/mL (5.67 mM); Clear solution

    This protocol yields a clear solution of ≥ 1.43 mg/mL (saturation unknown).

    Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (14.3 mg/mL) to 400 μL PEG300, and mix evenly; then add 50 μL Tween-80 and mix evenly; then add 450 μL Saline to adjust the volume to 1 mL.

    Preparation of Saline: Dissolve 0.9 g sodium chloride in ddH₂O and dilute to 100 mL to obtain a clear Saline solution.
  • Protocol 2

    Add each solvent one by one:  10% DMSO    90% (20% SBE-β-CD in Saline)

    Solubility: ≥ 1.43 mg/mL (5.67 mM); Clear solution

    This protocol yields a clear solution of ≥ 1.43 mg/mL (saturation unknown).

    Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (14.3 mg/mL) to 900 μL 20% SBE-β-CD in Saline, and mix evenly.

    Preparation of 20% SBE-β-CD in Saline (4°C, storage for one week): 2 g SBE-β-CD powder is dissolved in 10 mL Saline, completely dissolve until clear.
  • Protocol 3

    Add each solvent one by one:  10% DMSO    90% Corn Oil

    Solubility: ≥ 1.43 mg/mL (5.67 mM); Clear solution

    This protocol yields a clear solution of ≥ 1.43 mg/mL (saturation unknown). If the continuous dosing period exceeds half a month, please choose this protocol carefully.

    Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (14.3 mg/mL) to 900 μL Corn oil, and mix evenly.

In Vivo Dissolution Calculator
Please enter the basic information of animal experiments:

Dosage

mg/kg

Animal weight
(per animal)

g

Dosing volume
(per animal)

μL

Number of animals

Recommended: Prepare an additional quantity of animals to account for potential losses during experiments.
Please enter your animal formula composition:
%
DMSO +
% 
+
%
Tween-80 +
%
Saline
Recommended: Keep the proportion of DMSO in working solution below 2% if your animal is weak.
The co-solvents required include: DMSO, . All of co-solvents are available by MedChemExpress (MCE). , Tween 80. All of co-solvents are available by MedChemExpress (MCE).
Calculation results:
Working solution concentration: mg/mL
Method for preparing stock solution: mg drug dissolved in μL  DMSO (Stock solution concentration: mg/mL).

*In solvent : -80°C, 1 year; -20°C, 6 months (protect from light)

The concentration of the stock solution you require exceeds the measured solubility. The following solution is for reference only. If necessary, please contact MedChemExpress (MCE).
Method for preparing in vivo working solution for animal experiments: Take μL DMSO stock solution, add μL . μL , mix evenly, next add μL Tween 80, mix evenly, then add μL Saline.
 If the continuous dosing period exceeds half a month, please choose this protocol carefully.
Please ensure that the stock solution in the first step is dissolved to a clear state, and add co-solvents in sequence. You can use ultrasonic heating (ultrasonic cleaner, recommended frequency 20-40 kHz), vortexing, etc. to assist dissolution.

  • [1]. Song W, et al. Plug-and-play fluorophores extend the spectral properties of Spinach. J Am Chem Soc. 2014 Jan 29;136(4):1198-201.  [Content Brief]

    [2]. Strack RL, et al. Using Spinach-based sensors for fluorescence imaging of intracellular metabolites and proteins in living bacteria. Nat Protoc. 2014 Jan;9(1):146-55.  [Content Brief]

  • [1]. Song W, et al. Plug-and-play fluorophores extend the spectral properties of Spinach. J Am Chem Soc. 2014 Jan 29;136(4):1198-201.

    [2]. Strack RL, et al. Using Spinach-based sensors for fluorescence imaging of intracellular metabolites and proteins in living bacteria. Nat Protoc. 2014 Jan;9(1):146-55.

* Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 1 year; -20°C, 6 months (protect from light). When stored at -80°C, please use it within 1 year. When stored at -20°C, please use it within 6 months.

Optional Solvent Concentration Solvent Mass 1 mg 5 mg 10 mg 25 mg
DMSO 1 mM 3.9648 mL 19.8240 mL 39.6479 mL 99.1198 mL
5 mM 0.7930 mL 3.9648 mL 7.9296 mL 19.8240 mL
10 mM 0.3965 mL 1.9824 mL 3.9648 mL 9.9120 mL
15 mM 0.2643 mL 1.3216 mL 2.6432 mL 6.6080 mL
20 mM 0.1982 mL 0.9912 mL 1.9824 mL 4.9560 mL
25 mM 0.1586 mL 0.7930 mL 1.5859 mL 3.9648 mL
30 mM 0.1322 mL 0.6608 mL 1.3216 mL 3.3040 mL
40 mM 0.0991 mL 0.4956 mL 0.9912 mL 2.4780 mL
50 mM 0.0793 mL 0.3965 mL 0.7930 mL 1.9824 mL
60 mM 0.0661 mL 0.3304 mL 0.6608 mL 1.6520 mL
80 mM 0.0496 mL 0.2478 mL 0.4956 mL 1.2390 mL
100 mM 0.0396 mL 0.1982 mL 0.3965 mL 0.9912 mL
  • No file chosen (Maximum size is: 1024 Kb)
  • If you have published this work, please enter the PubMed ID.
  • Your name will appear on the site.
  • Others
  • Fluorescent Dye
Help & FAQs
  • Do most proteins show cross-species activity?

    Species cross-reactivity must be investigated individually for each product. Many human cytokines will produce a nice response in mouse cell lines, and many mouse proteins will show activity on human cells. Other proteins may have a lower specific activity when used in the opposite species.

Keywords:

DFHBI1241390-29-3Fluorescent DyeInhibitorinhibitorinhibit

Vos produits récemment consultés:

Demande en ligne

Your information is safe with us. * Required Fields.

Bulk Inquiry

Inquiry Information

Nom du produit:
DFHBI
Cat. No.:
HY-110250
Quantité:
MCE Japan Authorized Agent:

Avis client

Thank You for Your Feedback!

Request for HNMR Report

Please fill out this form to request the QC report. We will send it to your Email address shortly.

Your information is safe with us. * Required Fields.

Request for HNMR Report

We have received your request and will respond to you as soon as possible.

Vous serez peut-être également intéressé par les produits suivants :



Référence
Description
Cond.
Prix HT
A835-100MG
AMPHIPOL A8-35
 100MG 
C317-5GM
CHAPSO, ANAGRADE
 5GM 
HY-K0217-1mL
Anti-Flag Affinity Gel
 1mL